The bend radius can be anything that your design needs. Minimum inside bend radius would be material thickness.
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
In general, yes. But... minimum bend radius can be less than the material thickness. It depends on the material being bent, process and other factors.
This isn't really a drafting or GD&T question however.
[green]"I think there is a world market for maybe five computers."[/green]
Thomas Watson, chairman of IBM, 1943.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
