Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bend Drafting Standards In Flate State

Status
Not open for further replies.

HyeProfile

New member
Joined
Dec 12, 2005
Messages
1
Location
CA
I was wondering what ANSI/ASME requirements and suggestions are there for representing a bend in a top view of a flattened part.

Also, what are most commonly used: BL, BKL, FBL, ML??? And which of these are the bare minimum required?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top