Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bandsaw blade 1

Status
Not open for further replies.
waldospe

waldospe

Chemical
May 29, 2006
1
I'm using a metal-cutting bandsaw to cut thin slices of 4.5" round 6061 aluminum stock. What is the best blade choice for a smooth face and this thick of stock?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Use as coarse of a tooth as you can find, lots of coolant, and a very consistant feed. About 200-250 fpm blade speed should do nicely for a high-speed blade. A finer tooth will only gum up the kerf and leave lots of saw marks, you want those chips OUT of the cut asap.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom