velmurugananth
Mechanical
Hi guys ,
Currently I am working in NX 8.5. I faced an issue while drafting an assembly file.
Actually while placing the BOM balloon in drafting, I used to select a point on the line of a particular component. But this seemed to be not fully associated with that particular component. Especially when the component is re positioned the associativity would be lost.
Is there any alternate method of positioning the balloon by selecting the component instead of a single point on the line of that particular component.
Please suggest a best solution for this.
Thank You,
VEL
Currently I am working in NX 8.5. I faced an issue while drafting an assembly file.
Actually while placing the BOM balloon in drafting, I used to select a point on the line of a particular component. But this seemed to be not fully associated with that particular component. Especially when the component is re positioned the associativity would be lost.
Is there any alternate method of positioning the balloon by selecting the component instead of a single point on the line of that particular component.
Please suggest a best solution for this.
Thank You,
VEL
