Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Balloon dimensions in NX drawing and export list to Excel

Status
Not open for further replies.
dwang953

dwang953

Mechanical
Joined
Jun 10, 2015
Messages
1
Location
US
I am new to NX and was wondering how I could balloon all of the dimensions and instructions on an engineering drawing and then export a numbered list of them to an Excel file. I need the list for engineers in the Quality department to perform inspections.
 
Status
Not open for further replies.

Similar threads

jtozer
  • Locked
  • Question Question
Journal to set cell settings and export Parts List
Replies
4
Views
2K
jtozer
jtozer
Jashe
  • Question Question
How to create Radial Section Cut on NX Drawing
Replies
5
Views
11K
SDETERS
SDETERS
Buitung
  • Locked
  • Helpful tip Helpful tip
Automatic Measure and Export Excel
Replies
2
Views
846
moog3
moog3
Jian Wang
  • Locked
  • Question Question
Export points coordinate from NX to txt
Replies
4
Views
2K
Jian Wang
Jian Wang
gurucallie
  • Locked
  • Question Question
Embed an EXcel file into NX 2027 so the file drives a model and stays with the model file
Replies
3
Views
3K
cowski
cowski

Part and Inventory Search

Sponsor

Back
Top