Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

[b]UGNX3: how to use BOM function[/b] 1

Thread starter gakare
Start date Feb 1, 2006

Status: Not open for further replies.

Feb 1, 2006

gakare

Automotive

I need to write a BOM on my parts and assembly using a customized parts list. I found the flyout standard forms which are not quite right. I have attributed each part with mat'l and stock sizes. Where is the BOM function located and how does it work? Using NX3.
Thanks in advance if I am unable to respond.