Hi, I am having some problems with analysing a threaded connection, where the bolt is hollow. So far the setup is complete, but I can't find a way to put the BC and loads correct on the model. Please, can someone help out? I can send the files needed if anyone have a chance to help out..
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Axisymmetric Analysis of a threaded connection
- Thread starter blckwtr
- Start date
- Thread starter
- #2
I did get the solution to converge once, but I still get a lot of error messages saying time increment is larger than expected, and I have set it to 1e-20, getting the solution to almost converge, but the error message is coming still. I would really like for someone to have a look at this, since I am doing several analysis with different load scenarios. Is there some way to calculate the time increment, or am I doing something else wrong?
- Status
Similar threads
