Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
AWS D1.6 2
- Thread starter GRoberts
- Start date
-
2
- #2
Hi GRoberts:
The D1.6:1999, subsection 1.2 denotes the use of the following types of SS's: austenitic, ferritic, martensitic, and austenitic, semi-austenitic and martensitic PH stainless steels, and duplex and dissimilar metals applications. Other limitations include:
C less than or equal to 0.5%
Cr equal or greater than 10.5%
Fe exceeding any other single element
Only the austenitic types are prequalified with filler metals that "...normally produce small a amount of ferrite..." per 1.2.2 of the code.
The D1.6:1999, subsection 1.2 denotes the use of the following types of SS's: austenitic, ferritic, martensitic, and austenitic, semi-austenitic and martensitic PH stainless steels, and duplex and dissimilar metals applications. Other limitations include:
C less than or equal to 0.5%
Cr equal or greater than 10.5%
Fe exceeding any other single element
Only the austenitic types are prequalified with filler metals that "...normally produce small a amount of ferrite..." per 1.2.2 of the code.
- Status
Similar threads
- Locked
- Question
- Locked
- Question