soildynamics
Civil/Environmental
I am using ABAQUS standard (Implicit) to model elastoplastic materials. However, because I have materials failure (plasticity cannot converge at some points) the model cannot converge. What should I do in this case
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Avoiding Material Failure in ABAQUS(Implicit)
- Thread starter soildynamics
- Start date
- Status
dariushtari99
Mechanical
hi
what kind of damage nitiation have you used?most of methods are available in EXPLICIT solver.what is the problem you are solving?Is it not possible to solve the problem using Explicit solver?
Dariush
what kind of damage nitiation have you used?most of methods are available in EXPLICIT solver.what is the problem you are solving?Is it not possible to solve the problem using Explicit solver?
Dariush
- Thread starter
- #3
soildynamics
Civil/Environmental
No it is not as I have a porous media that is not supported by Explicit
- Status
Similar threads
- Solved
- Question
- Locked
- Question