My co. charges their tumblers with 40mm size styrofoam balls, coats them (spray)with an epoxy and then some sort of fiber...all designed to increase the density to a specified point. What would be considered a "best" design for the subject baffles to assure a thorough coating of epoxy and fibers?
Some of our tumblers provide good results, some do not. I feel certain that there are those on this board who can offer some suggestions to improve our lot in this mfg operation.
Thanks,
9751jld
Some of our tumblers provide good results, some do not. I feel certain that there are those on this board who can offer some suggestions to improve our lot in this mfg operation.
Thanks,
9751jld
