Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Autopipe v8i Plus: General shear stress and shear force output

Thread starter dldhdz
Start date Jun 28, 2013

Status: Not open for further replies.

Jun 28, 2013

dldhdz

Mechanical

Dear all, if I was not mistaken, the direct shear stress will not be included by default for all piping code options except GENERAL and Stoomwezen. I was wondering whether it's possible to retrieve in-plane and out-of-plane shear forces from the analysis or not? Appreciated for any advice. Many thanks in advance. Cheers.