Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Automatic Switching of Dimensions During NOTE Creation

  • Thread starter Thread starter maurya
  • Start date Start date
Status
Not open for further replies.
M

maurya

Guest
Whenever you start the process of NOTE creation, use this technique to make the dimensions appear as their symbolic names instead of numerical values.

Set the following config.pro option



SWITCH_DIMS_FOR_NOTES <YES>
 
Status
Not open for further replies.

Similar threads

M
  • Question Question
Moving Radial Dimensions
Replies
7
Views
21K
3DDave
3DDave
Somers
  • Locked
  • Question Question
Creo - year of creation in a note
Replies
12
Views
1K
Somers
Somers
S MORIN
  • Locked
  • Question Question
ptc_material_description in a note
Replies
0
Views
1K
S MORIN
S MORIN
whatev-nvm
  • Locked
  • Question Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
1K
whatev-nvm
whatev-nvm
freerangequark
  • Locked
  • Question Question
Control of a dimension or parameter in simplified rep?
Replies
1
Views
2K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top