Flashoflight
Industrial
Our company has purchased a 48" x 20' autoclave to cure extruded rubber shapes. I am looking for some good information (book or article) on the setup of an autoclave, controls, and safety.
Steve
Steve
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Autoclave Beginner - need suggestions
- Thread starter Flashoflight
- Start date
- Status
gr2vessels
Mechanical
If it is a standard, off shelf autoclave, the set-up and controls are detailed in the little booklet attached to the guarantee sheet, together with the list of your nearest repair shop.
Otherwise, you might have to disclose to this forum the make and model of your autoclave, if you are really expecting some advice.
Cheers,
gr2vessels
Otherwise, you might have to disclose to this forum the make and model of your autoclave, if you are really expecting some advice.
Cheers,
gr2vessels
PVinspector
Industrial
I am looking for some good information (book or article) on the setup of an autoclave, controls, and safety.
Don't open the door when it is under pressure
Don't open the door when it is under pressure
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
