Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Attrubute update from spreadsheet

Thread starter GTI18T
Start date Jun 2, 2005

Status: Not open for further replies.

Jun 2, 2005

GTI18T

Industrial

I had set up a master model in UG V18. In that part I had imported attributes into a spreadsheet for the title block information. I could input things such as drawn by and checked by in the spreadsheet and it would update on the drawing. Since my company upgraded to NX2 I have not been able to get the attributes to updae from the spreadsheet.

has anyone had this problem? Is there a solution?

Thanks.