cadmaster10
Mechanical
In AutoCAD when I inserted an attributed BOM and the verbage was longer than the allowed field, I could change the font width to allow it to fit. Draftsite does not seem to allow me to do this. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Attributed text width
- Thread starter cadmaster10
- Start date
- Status
Similar threads