Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Assembly Sequence NX 8.5
- Thread starter UGperson
- Start date
JohnRBaker
Mechanical
Based on how you asked the question I assume that you've noticed that this is not working in NX 8.5, eh? And yes, I just verified that fact (and it did work in at least NX 7.5 and NX 8.0). That being said, it DOES work in NX 9.0, so whatever happened in NX 8.5, it appears to have been fixed.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status
