I'm new to Aspen Plus V8.0. What simulation model (i.e., a separator, heat exchanger, ...) should be used for an isentropic flash (liquid, vapor, two-phase)? What about for an isenthalpic flash? I'm looking for physical properties to model single phase and two-phase flow relief devices. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Aspen simulation model choice for flashing
- Thread starter chemter
- Start date
- Status
Similar threads
- Question
- Question