reo682
Mechanical
- Jun 3, 2019
- 5
Hello,
I would like to request you to point me to ASME reference about following details.
1. Can we add dimensions to section views
(I was told and followed that its better to show section view to clarify some detail( for example a hole..etc) than showing hidden line view. Its OK to dimension for a section view)
2. Is it OK to show hidden line views for obviously simple part, for example square tube with holes through both walls,?
(I was told and followed that shall not show hidden lines unless to clarify or avoid any confusion)
thanks,
pkpavv
I would like to request you to point me to ASME reference about following details.
1. Can we add dimensions to section views
(I was told and followed that its better to show section view to clarify some detail( for example a hole..etc) than showing hidden line view. Its OK to dimension for a section view)
2. Is it OK to show hidden line views for obviously simple part, for example square tube with holes through both walls,?
(I was told and followed that shall not show hidden lines unless to clarify or avoid any confusion)
thanks,
pkpavv