Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Sect VIII Division 1 v/s Division-2

Status
Not open for further replies.
akash_65

akash_65

Mechanical
Jun 8, 2021
3
Which of the BPV standard of ASME Sect. VIII div.1 or Div.2 is better for process vessel design ?

What are the advantages or disadvantages of using ASME Sect. VIII div. 2 over ASME Sect. VIII Div.-1 ?

Thanks...!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Please, contact a pressure vessel engineer.

Regards
 
Upvote 0 Downvote
You'll need to quantify what you mean by advantage vs disadvantage. In what context?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question
ASME Section VIII Division 2 - Protecion Against Local Failure
Replies
6
Views
5K
antoniol
A
A
  • Locked
  • Question
5.4.2. Buckling analysis - Method A - ASME Section VIII Division 2 - negative EigenVaue
Replies
2
Views
2K
antoniol
A
Waqas-999
  • Locked
  • Question
Temperature limit of ASME Section VIII Division 1 1
Replies
4
Views
514
XL83NL
XL83NL
R
  • Question
Exclusion From the Scope of ASME BPVC VIII-1 - water-based solution
Replies
4
Views
6K
goutam_freelance
goutam_freelance
dig1
  • Locked
  • Question
Versions of ASCE 7 for Section VIII, Division 1 Vessels
Replies
2
Views
610
dig1
dig1

Part and Inventory Search

Sponsor

Back
Top Bottom