Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Sec. VIII - Pressure Vessel Design - Stiffener ring for Nozzle neck.

Status
Not open for further replies.
MOHAMMED89

MOHAMMED89

Mechanical
Joined
Feb 25, 2015
Messages
85
Location
AE
i need to design boot for Pressure vessel using PVElite,

So i design the boot as nozzle and instead of flange i put dished end.
My concern is since the boot height is very large i need to provide stiffener ring (minimum two no.).


Anyone please advise me how to insert this stiffening ring for this boot (Nozzle neck) in PVElite.
 
Status
Not open for further replies.

Similar threads

Sajjad2164
  • Question Question
ASME VIII-1 Nozzle Spacing Clash
Replies
7
Views
11K
Si-bo
Si-bo
Ronak_Patel
  • Locked
  • Question Question
commercial software for design of pressure vessel and heat exchanger according to ASME SEC ||| for nuclear application.
Replies
1
Views
5K
MJCronin
MJCronin
LS_SMS
  • Question Question
ASME Sec. VIII, Div. 2, Annex 3-F, Eqn. 8
Replies
6
Views
8K
LS_SMS
LS_SMS
pat7987
  • Question Question
ASME Section VIII Div.1 formed head straight flange (skirt) design for external loads
Replies
4
Views
7K
KevinNZ
KevinNZ
Paul Arthur
  • Question Question
Pressure vessel under negative Pressure
Replies
13
Views
8K
Brian Malone
Brian Malone

Part and Inventory Search

Sponsor

Back
Top