Hi everybody.
I'm preparing new formats for ASME drawing.
I need also to define a zoning for the formats.
Reference is ASME 14.1M-2012.
In the table 4-1 the zones for A0 size is defined with 50mm length
BUT starting from ... ? "format" bottom right vertex or "margin" bottom right vertex ?
In any case I got zones from A to Q (in vertical) and not P as shown in the fig. 4-1 example.
How to solve this problem in your opinion ? (if it's a problem )
Thanks
Pier
I'm preparing new formats for ASME drawing.
I need also to define a zoning for the formats.
Reference is ASME 14.1M-2012.
In the table 4-1 the zones for A0 size is defined with 50mm length
BUT starting from ... ? "format" bottom right vertex or "margin" bottom right vertex ?
In any case I got zones from A to Q (in vertical) and not P as shown in the fig. 4-1 example.
How to solve this problem in your opinion ? (if it's a problem )
Thanks
Pier
