Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Arrange Symbols..

Status
Not open for further replies.
00abc007

00abc007

Automotive
Joined
Feb 27, 2006
Messages
1
Location
US
Hi..

I'm using SDRC I-deas 10nx. In Master assembly, I couldnt figure out what to do to make "Arrange Symbols" always show both the Assembly dimensions and leaders.

It toggles between just showing the constraint dimensions as Matrix & showing the same with the leaders.I always want it to show with leaders but I dont know how do it.

I appreciate any help.
Thanks,

HK.
 
Status
Not open for further replies.

Similar threads

dklarz
  • Locked
  • Question Question
ANSI drafting symbols
Replies
3
Views
245
sbozy25
sbozy25
pesamon
  • Locked
  • Question Question
How to clean symbols or extract a selection from a drawing? (novice)
Replies
3
Views
227
eyukins
eyukins

Part and Inventory Search

Sponsor

Back
Top