Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Area Replacement Rule, WRC, and FEA 1

Status
Not open for further replies.
sxz

sxz

Mechanical
Joined
Aug 16, 2005
Messages
40
Location
CA
Hi, I have a nozzle reinforcement calculation. As per the UG-37, the area replacement rule, Aa < Ar, it fails, but WRC or FEA results pass. Can I use the WRC or FEA result for fabrication?
Thanks.
 
Sort by date Sort by votes
Ok, the old order before design gamble. Can you put internal projection? Even 1" should do.
 
Upvote 0 Downvote
Yes, it works. It is a better option than adding a repad.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CoFe2
  • Locked
  • Question Question
NBIC Replacement Nameplate
Replies
2
Views
2K
CoFe2
CoFe2
Virendra Patel
  • Locked
  • Question Question
Replacement of same pressure vessel part (HX bonnet) needs only R-1 report.
Replies
2
Views
489
rachnatbovo
rachnatbovo
victor6397
  • Question Question
Plastic Collapse and ratcheting assessment locations
Replies
1
Views
2K
TGS4
TGS4
sarawana
  • Locked
  • Question Question
WRC 297 Limitation on Dn/Tn ratio
Replies
1
Views
609
DriveMeNuts
DriveMeNuts
hugo50ml
  • Locked
  • Question Question
Concerns Regarding ASME Certification and Company Conduct
Replies
0
Views
2K
hugo50ml
hugo50ml

Part and Inventory Search

Sponsor

Back
Top