Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
area (2)
- Thread starter krzysiek
- Start date
Yes.
In the variable table, make sure your "area_samepart" variable is EXPOSED. Give it a easy-to-use name and you should then be able to see this variable when the part is attached to the draft. You can see it either through property text or through a column in the BOM.
--Scott
For some pleasure reading, try FAQ731-376
In the variable table, make sure your "area_samepart" variable is EXPOSED. Give it a easy-to-use name and you should then be able to see this variable when the part is attached to the draft. You can see it either through property text or through a column in the BOM.
--Scott
For some pleasure reading, try FAQ731-376
- Status
Similar threads
- Locked
- Question
- Locked
- Question