Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

are and volume number after overlap

Status
Not open for further replies.
wijono

wijono

Electrical
Joined
Dec 16, 2003
Messages
14
Location
MY
Every time we overlap areas or volumes, the number of areas or volumes will be changed.
How to keep areas or volumes number so we can easily identify it especially in the batch mode?
 
Status
Not open for further replies.

Similar threads

T
  • Question Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
4K
TOM1345
T
Ahmed_abdelgawad
  • Question Question
CDB and ‘prnsol,s’
Replies
0
Views
6K
Ahmed_abdelgawad
Ahmed_abdelgawad
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
Faraz1997
  • Locked
  • Question Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
1K
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top