Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Apply edge on a load and also define Tensile yieldstrength, compressive yield strength in ABAQUS

Thread starter Sri Harsha
Start date Dec 9, 2017

Status: Not open for further replies.

Dec 9, 2017

Sri Harsha

Aerospace

Hi,

Under Material properties tab,I could not find any option to input tensile yieldstrength and compressive yield strength .
Also,How can one apply load on an edge in ABAQUS? I tried the option "LineLoad" , but it requires entire body as an input

I would be really glad,if someone can explain these two things.