Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Appendix 14 1

Status
Not open for further replies.
5pointslow

5pointslow

Mechanical
Joined
Feb 1, 2006
Messages
13
Location
CA
I am attempting to place a nozzle in a flat head. The size of the hole is greater than half the diameter of the head. Per Code, calculations should be done per Appendix 14. However, in Compress I just receive a error that nozzle size is greater than D/2. Is there any way to invoke Appendix 14 calculations?
Thanks.
 
Status
Not open for further replies.

Similar threads

Champ58
  • Locked
  • Question Question
ASME Section-VIII Div-1 Appendix-1-4(d) Tori-spherical head calculation
Replies
0
Views
952
Champ58
Champ58
doct9960
  • Locked
  • Question Question
ASME PCC-1 Appendix O Calculations
Replies
4
Views
1K
Morts81
Morts81
MecEngSelli
  • Locked
  • Question Question
Appendix 2-6 for COMPRESS
Replies
2
Views
374
Mech2325
Mech2325
BigTank
  • Locked
  • Question Question
UG-27 or Appendix 1
Replies
2
Views
385
TomBarsh
TomBarsh
08tramp
  • Locked
  • Question Question
How to apply Appendix S on Appendix 2 Flanges
Replies
8
Views
658
08tramp
08tramp

Part and Inventory Search

Sponsor

Back
Top