Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

App. time and cost for stripping, please?

Status
Not open for further replies.
tomwalz

tomwalz

Materials
Joined
May 29, 2002
Messages
947
Location
US
Time and cost for stripping

I need any sort of rough figures or ranges for time and cost of stripping. I believe that is the correct term for pulling out pipe to replace a worn drill head.

Thank you,
Tom
 
Status
Not open for further replies.

Similar threads

T
  • Locked
  • Question Question
Typical cost for installation of wind girders quotation. Is this reasonable in todays climate?
Replies
1
Views
1K
Tom O'Brien
T
edgardoom
  • Locked
  • Question Question
Ideas of softwares for Oil and Gas industry
Replies
1
Views
1K
1503-44
1503-44
ncnpiping
  • Locked
  • Question Question
Pickling and Passivation for SS weld joints
Replies
4
Views
2K
EdStainless
EdStainless
aegis4048
  • Locked
  • Question Question
Recommended temperature for Heater Treater
Replies
2
Views
3K
EdStainless
EdStainless
I
  • Locked
  • Question Question
Request for a Specification Document for a Heat Exchanger in the Oil Refining Sector
Replies
3
Views
6K
0707
0707

Part and Inventory Search

Sponsor

Back
Top