Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

API: REQ: Part display mode method?

Thread starter sygenics
Start date Mar 27, 2008

Status: Not open for further replies.

Mar 27, 2008

sygenics

Electrical

Hi

I'm trying to get and set a bunch of parts display modes using the API (SW08) but I've had no luck seeing what the correct method is for accessing the display mode (wireframe/shaded etc) of a part within an assembly. Anyone point me in the right direction?

thanks

Rich