Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

api 1104

Status
Not open for further replies.

gujula

Mechanical
Joined
Apr 15, 2006
Messages
2
Location
IN
WPS QUALIFIED DIAMETER RANGE AND THICKNESS RANGE CALCULATION ON WHAT BASIS OR WHICH TABLE?
WE HAVE ONE PQR WITH 36" X31.75MM. WHAT IS THE DAIMETER AND THICKNESS RANGE QUALIFIED?
PLEASE CLARIFY
GUJULA J RAJU


Gujula J Raju
QA/QC ENGINEER/WELDING & PIPING
 
Mr Raju,
Do you have a copy of API 1104 ?
Strongly suggest you open it up and have a look - the answer to your question takes about 1 minute to locate if you are familiar with the code and probably 2-3 minutes if you are not familiar.
Regards,
Kiwi
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top