I'm looking for some tips on Rubber (NITRILE) Mold Releaser, application is Compression Molding, temp. 340 F. I'm having trouble with releasing the part (part breaks during extraction from the mold ). Need some tips on different kind of Rubber Mold Releaser that I can try (I have tried 787 & 1725L both MCLUBE and I'm looking for something better and more permanet). Any kind of suggestion on the Mold Releaser brand and proccedure is appriciated. Thank you, Genti
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Anybody has experience with Rubber Mold Releaser? 1
- Thread starter genti1
- Start date
-
1
- #2
My company manufactures mold releases that may fit the bill.
Crystal® Mold Releases are water-based, semi-permanent mold releases that are used with various rubbers and other polymers (cast urethanes, fiberglas, etc.).
Info can be found on my company's web site Crystal 1053 is used for molding many different types of rubber and would probably work in your application. Info can be found here:
Regards,
tom
Crystal® Mold Releases are water-based, semi-permanent mold releases that are used with various rubbers and other polymers (cast urethanes, fiberglas, etc.).
Info can be found on my company's web site Crystal 1053 is used for molding many different types of rubber and would probably work in your application. Info can be found here:
Regards,
tom
- Status
Similar threads
- Locked
- Question