smithson1984
Marine/Ocean
Hi all,
I am relatively new to ANSYS and I have version 14.5. Whilst trying to conduct a Static Structural analysis on a fairly large (c.30,000 elements) structure I am receiving an error which suggests using the ENORM command which is apparently found under PREP7 command heading??? I'm a little confused by this. It seems like older versions of ANSYS were controlled by these types of commands but I can't work out how to do it in ANSYS 14.5.
If anyone out there can give me some pointers or tips or advice then I'd greatly appreciated!
Many thanks in advance,
Ian
I am relatively new to ANSYS and I have version 14.5. Whilst trying to conduct a Static Structural analysis on a fairly large (c.30,000 elements) structure I am receiving an error which suggests using the ENORM command which is apparently found under PREP7 command heading??? I'm a little confused by this. It seems like older versions of ANSYS were controlled by these types of commands but I can't work out how to do it in ANSYS 14.5.
If anyone out there can give me some pointers or tips or advice then I'd greatly appreciated!
Many thanks in advance,
Ian