Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS LOADSTEP HELP

Thread starter mugametal
Start date May 25, 2011

Status: Not open for further replies.

May 25, 2011

mugametal

Mechanical

Hi all,

I can't figure out how to make a new load step in ANSYS.

Say I have a statics problem which I solved as Load step 1, now I want to go back and change the applied force. I want to solve this setup as Load Step 2..so during Post Processing I can view results of two different load sets.

How do I do this?

Thanks.