Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS 14 MADPL Path Question

Status
Not open for further replies.
BrentP

BrentP

Materials
Joined
Apr 12, 2013
Messages
8
Location
CA
Hello, I'm doing a run of simulations which has 1 or 2 loads changed. I'm plotting a path and graphing it.

My issue is every time I run a new simulation, I need to redefine my paths each run.

My question is, Is it possible to set the paths so as to keep them defined every sim? I've seen archive path but can not quite figure it out.

Please say there is a way, as it is quite annoying.

Thanks.
 
Status
Not open for further replies.

Similar threads

O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner
S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
somebodyfromworld
  • Locked
  • Question Question
ACT extensions for Ansys
Replies
0
Views
1K
somebodyfromworld
somebodyfromworld
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X

Part and Inventory Search

Sponsor

Back
Top