Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSI Standard for pneumatic plumbing of shot pins.

Status
Not open for further replies.
dtwo

dtwo

Automotive
Joined
Oct 17, 2002
Messages
137
Location
US
We have an application where we are using a shot pin (driven by an air cylinder) to fix a rotating trunnion while performing maintenance. Does anyone know if there is a safety standard that outlines the safest way to plumb the pneumatic circuit?
 
Status
Not open for further replies.

Similar threads

Tmoose
  • Locked
  • Question Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
1K
Tmoose
Tmoose
ShlomoB
  • Locked
  • Question Question
Adding the same balloon multiple times in a drawing (ANSI)
Replies
3
Views
3K
ewh
ewh
Nathan Gardner
  • Locked
  • Question Question
how to show Pneumatic diagram with options
Replies
0
Views
699
Nathan Gardner
Nathan Gardner
Mauro Nicoli
  • Locked
  • Question Question
ANSI 16.5
Replies
6
Views
1K
Mauro Nicoli
Mauro Nicoli
Quality Improvement 1
  • Locked
  • Question Question
ANSI Standard requiring changing part number vs revision
Replies
3
Views
1K
looslib
looslib

Part and Inventory Search

Sponsor

Back
Top