Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSI B92.1-1970 Flat Root MAjor Diameter Fit

Status
Not open for further replies.
MrMacHinery

MrMacHinery

Mechanical
Joined
Feb 17, 2009
Messages
1
Location
CA
I understand most of the standard except I can't seem to figure out variable "c" for Major Diameter Fit, Item #10 Tv max where does this value come from and how is it calculated? I find no other reference to this in the standard
 
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question Question
Adding the same balloon multiple times in a drawing (ANSI)
Replies
3
Views
3K
ewh
ewh
Tmoose
  • Locked
  • Question Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
1K
Tmoose
Tmoose
Mauro Nicoli
  • Locked
  • Question Question
ANSI 16.5
Replies
6
Views
1K
Mauro Nicoli
Mauro Nicoli
Quality Improvement 1
  • Locked
  • Question Question
ANSI Standard requiring changing part number vs revision
Replies
3
Views
1K
looslib
looslib
Struct-007
  • Locked
  • Question Question
AISC 360-16 Hole Diameter
Replies
1
Views
989
Struct-007
Struct-007

Part and Inventory Search

Sponsor

Back
Top