Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anchor bolt distances on baseplate BS5950

Status
Not open for further replies.

ronronpcengtips

Structural
Aug 27, 2007
10
Can anybody point me to the right direction as to how to decide the anchor bolt distance from edge of column to center of anchor bolt in designing baseplates using BS5950 code? Thanks in advance.
 
Replies continue below

Recommended for you

Have perused now the code and seems not to say anything about. However we must infer a minimum of 1.25D for standard clearance holes just to be able to drive the nut or bolt, and likely more will be even better. You have ample distance to go from the web or flange or box or pipe face, at least to 14 times the lesser plate thicknness, distance to which we may assume it is adequately stiffened from (and more, since the values are for non stiffened plates).

See section 6.2 Connections using bolts.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor