Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Analyzing a fill surface area in Drafting

Status
Not open for further replies.

b8man

Mechanical
Joined
Feb 7, 2006
Messages
3
Location
US
Once you have created an area fill in Drafting...is there any way to just analyze it to find out what the filled surface area is?

Thanks in advance.
 
The only way I could think of, select the profile geometry and Cntrl C to copy, Go into GSD, create a sketch, Cntrl V to paste. exit sketcher. Use the fill surface command in GSD, then measure surface area.

Regards,
Derek
 
Thanks...will give it a try!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top