Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Analysis - Writing Case Control

Status
Not open for further replies.
ksimpson

ksimpson

Mechanical
Joined
Oct 4, 2013
Messages
2
Location
US
I'm new to nastran and I'm having trouble getting an analysis to run. Everything works fine but when I initiate the analysis, it says writing case control and simply times out. I can't seem to figure out what the problem is. Any advice?
 
Sort by date Sort by votes
It is really hard to figure out the reason with so little information. What GUI are you using, what version of Nastran, and what operation system? Can you post your Nastran input file?
 
Upvote 0 Downvote
Thanks but I worked it out. I was connected to a VPN and once I disconnected it working.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

N
  • Question Question
Patran/Nastran Buckling Analysis – SYSTEM FATAL MESSAGE 7340 (LNNHERR)
Replies
1
Views
6K
ThomasH
ThomasH
N
  • Question Question
Nonlinear Buckling Analysis after Pretensioning (Wrinkling Study – Patran/Nastran SOL 400)
Replies
0
Views
5K
Nic0
N
S
  • Locked
  • Question Question
Problem in Modal analysis
Replies
5
Views
4K
BlasMolero
BlasMolero
Itxusta
  • Locked
  • Question Question
2d axisymmetric analysis of a revolution part
Replies
3
Views
1K
Itxusta
Itxusta
catalina29
  • Locked
  • Question Question
Nastran SOL400 normal modes analysis with touching contact
Replies
1
Views
3K
karachun
karachun

Part and Inventory Search

Sponsor

Back
Top