I need to do a stress analysis test of a bolt cutter design. The applied load on the either handle is 50lbs. The design needs to be suitable for shearing fully hardened (grade 8) bolts up to 0.5 inch in diameter. If anyone can direct to me references or sketches that will be greatly appreciated. Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Analysis of bolt cutters
- Thread starter MEsd
- Start date
Similar threads
- Locked
- Question
- Question
