Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AISI Design Method

Status
Not open for further replies.
zishan99

zishan99

Mechanical
Joined
Mar 11, 2006
Messages
15
Location
GB
In PV ELITE "BASE RING DESIGN DATA" there is an option "USE AISI DESIGN METHOD".If i use this option with 46%(%applied to bolt area * bolt stress)then i got the reasonable gusset plate and top/bottom ring thickness of the 900# vessel.

Please advise the AISI DESIGN METHOD critaria.

Regards.
 
Status
Not open for further replies.

Similar threads

BasakAbhishek
  • Question Question
Shell forming method with low out of roundness for thin shell
Replies
17
Views
21K
r6155
r6155
SD12
  • Question Question
General Flange Design.
Replies
8
Views
12K
SD12
SD12
LS_SMS
  • Question Question
Can Service Pressure Exceed Design Pressure?
2
Replies
21
Views
32K
r6155
r6155
ElCidCampeador
  • Question Question
Creep design - EN 13445
Replies
4
Views
7K
GD2
GD2
mechengineer
  • Question Question
Variant of reverse flange design
Replies
10
Views
5K
TGS4
TGS4

Part and Inventory Search

Sponsor

Back
Top