I am trying to perform an advanced simulation using NX 7.5 on a gear set and am having trouble with the constraint used between the two gears. I am fully constraining the pinion and allowing the side gear to rotate. What contstraint do I apply so that the gear teeth can slide against each other while the deflection is occuring?
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
