Adjust a wall to roll-bended sheetmetal parts

[xcad]

Hello pro/e users



I have a question regarding to Pro/Sheetmetal module

Is it possible when I have a sheetmetal part, in which I have previous add a roll bend with a specifically radio, to create a flat or extruded wall ;. When iam trying to pick an edge to attach the wall proe doesn

 

[MBuchholtz]

I use sheet metal on a regular basis but am having a little trouble getting the feel of your question. do you have a screen shot of what you are trying to do? I think I may be able to help if I knew exactly what it was you were trying to.

If you would like you can email me a picture of what you are trying to do, mbuchholtz@eaglegrp.com



Hope I can help. Matthew

 

[xcad]

Mr Matthew



Thank you for you interest

i have found a solution



regards



karavasilis