Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
adding 3d roller bearing to shaft
- Thread starter iraniii
- Start date
I could not understand why it is not possible for you. Adding 3D bearing to a shaft especially if you know the bearing code (i.e. 6202), you just select the bearing location on the shaft; then select the bearing from the supplied list and then insert using aminsert.
Regards
Drkwing
Regards
Drkwing
- Status
Similar threads
