Add safety factor to Stress Solution in simulation.

[wacio]

Hi,

Safety factor plot is only available while running wizard initially. I searched everywhere trying to add it to simulation but cant figure it out. Anyone can give me hint?

Thank you.

NX7.5 + TC8.3

 

[wacio]

I'm not sure if receiving no answers due to lack of clarity in my original question. Let me add than: What I'm looking for is way to add safety factor to report after initial run of the stress wizard. Or at least to be able to view it after closing initial run of the wizard.

NX7.5 + TC8.3

 

[Arkance/PhoeNX]

The safety factor image is displayed in the HTML report when I test in NX7.5.
You can't edit the templates for the stress wizard. If you have a NX simulation license, you can save the .sim files created by the wizard and then view and customise the reports.
Otherwise without a simulation license, it's a one shot deal, once you've run the wizard, you have to create it over again.


Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[wacio]

TC is saving SIM file and I can re-run wizard. It is not displaying safety factor on the second run though.

NX7.5 + TC8.3