Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Active grain density calculation
- Thread starter andyjhn4
- Start date
Hi,
What kind of wheel are you loooking at?
I used Normal distribution for the grain heights for electroplated wheels. Measurements seemed to match well. I could calculate the active grain densiy from there depending on the wheel wear. The work is published in the 2004 ASME Journal of Mfg Sci. Let me know if you need any more info.
Good Luck,
Rama
What kind of wheel are you loooking at?
I used Normal distribution for the grain heights for electroplated wheels. Measurements seemed to match well. I could calculate the active grain densiy from there depending on the wheel wear. The work is published in the 2004 ASME Journal of Mfg Sci. Let me know if you need any more info.
Good Luck,
Rama
- Thread starter
- #3
I am looking at CBN wheels, I have been trialling a normal distribution technique from Hou and Komanduri in the journal of machine tools and manufacture, which gives some strange results at high removal rates. If you could point me to the paper you have been looking at I would be grateful....
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question