Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Achieving 208/212 deg F for sealing anodize at high altitudes 1

Status
Not open for further replies.

KetemaSaltillo

Aerospace
Jul 15, 2008
1
We have an anodize processing line and sealing with sodium dichromate calls for temperature range of 208 to 212 degrees Fahrenheit. Our facility is at a high-altitude location (4860 feet above sea level). It appears that we cannot achive a consistent reding of 208 degrees MIN in the dipping tank as the solution boils and evaporates very rapidly. We suspect that our location (altitude) makes it difficult to achive this temp (books say water boils at 202 def F at this altitude). Has anyone aver experienced a similar problem? Is there a reccomended anti-evaporation additive or other method to deal with this problem? Regards.
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor