Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
About the visualization of results with Abaqus CAE
- Thread starter nikko801
- Start date
Visualization Module - Options - Common -
Now choose the "no edges" or "free edges" or whatever...
In the same dialog box is the control on "Deformation Scale Factor". Choose "Uniform" and then type in a new factor.
PS: There's an icon (the top left in the toolbox which is on the left side of the viewport) that gets you into this dilaog box
Now choose the "no edges" or "free edges" or whatever...
In the same dialog box is the control on "Deformation Scale Factor". Choose "Uniform" and then type in a new factor.
PS: There's an icon (the top left in the toolbox which is on the left side of the viewport) that gets you into this dilaog box
- Status
Similar threads
- Locked
- Question
- Locked
