HI
How to check whether all the shear walls, columns pass the design check.
I've been looking at the display menu (show table>design>summary)
There is some errors stated there.
For columns it state that :
Reinforcing required exceeds maximum allowed
For shear wall:
Shear failure &
Reinforcing required exceeds maximum allowed
What is the consideration that I should take?
How to check whether all the shear walls, columns pass the design check.
I've been looking at the display menu (show table>design>summary)
There is some errors stated there.
For columns it state that :
Reinforcing required exceeds maximum allowed
For shear wall:
Shear failure &
Reinforcing required exceeds maximum allowed
What is the consideration that I should take?