themanish
Structural
- Feb 18, 2013
- 1
how to apply pressure horizontal on an inclined surface instead of normal to the surface in abaqus software?????
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Abaqus
- Thread starter themanish
- Start date
- Status
Had this problem when considering thermal expansion of a lining within a pressure vessel, and the load was provided by the equivalent radial load of the lining. You could apply a surface traction or load that counteracts the component of the load you don't require, or (if this case is similar) just include the lining in the model.
- Status
Similar threads
- Locked
- Question
- Locked
- Question